ENGLISH
I
About the Remote Control Unit
IInserting the Batteries
CD
Remove the remote control
CV
Set three R6/AA batteries
in
unit's rear cover. the battery compartment in the
indicated direction.
@
Put
the rear cover back on.
-N'U
a
o Use R6/AA batteries
in
this remote control.
o Replace the batteries with new ones if the set does not operate
even when the remote control unit
is
operated close to the unit.
(The supplied batteries are only for verifying operation.)
o When inserting the batteries, be sure
to
do so
in
the proper direction,
following the
"EEl"
and
"e"
marks
in
the battery compartment.
o
To
prevent damage or leakage of battery fluid:
Do not use a new battery together with
an
old one.
Do
not use
two
different types
of
batteries.
Do
not attempt to charge dry batteries.
Do not short-circuit, disassemble, heat or dispose
of
batteries
in
flames.
o If the battery fluid should leak, carefully
wipe
the fluid off the inside
of
the battery compartment and insert
new
batteries.
o Remove the batteries from the remote control unit if it will not be in
use for long periods.
o Used batteries should be disposed
of
in
accordance
with
the local
regulations regarding battery disposal.
7
Operating Range of the Remote Control
Unit
Point the remote control unit at the remote sensor when operating
it.
./
/ Approx.23feet!7m
~
_N,na
The set may function improperly or the remote control unit may not
operate if the remote control sensor
is
exposed
to
direct sunlight,
strong artificial light from
an
inverter type fluorescent lamp or infrared
light.
Remote Control Settings (Remote
Control Side)
Switches when the DVD·A1UDCI's remote control operates
another DENON
BD
players in
the
vicinity.
Set the remote control code simultaneously on the main unit, too.
For
how
to set codes, see
GUI
menu: "Other Setup" -
"Remote
Control Setting" - "Remote ID"
(&page
32).
[Remote control code setting]
: Set the remote control code to
'''''.
2 : Set the remote control code to "2".
o If the signal code of the remote control does not match the signal
code
of
the unit. the remote control code set on the unit
is
shown
on the display.
[Example]
If the code setting on the unit is "DENON 1", and the setting on the
remote control
is
"2", "PLAYER 1"
is
shown on the display.
_~['Ua
o Match the signal code
of
the remote control with the signal
code
of
the unit. If the remote control code
is
different. you cannot operate
the DVD-A
lU
DCI
with the remote control.
o
Even
if you change the remote control code, set
GUI
menu "Other
Setup" - "Remote Control setting" - "Receive Legacy Remocon"
(&
page 32) to
"Off"
when operating the DVD-AlUDCI
with
a
remote control other than DENON's.
To Next Page
Loading...
