ENGLISH
Adjusting the Picture Quality (Picture Control)
•
On
adjusting the brightness on the
output
side
of
bright parts on
the disc side, the normally hard to see bright parts become clearly
discernible images.
•
On
adjusting the brightness on the
output
side
of
dark parts on
the disc side, the normally hard to see dark parts become clearly
discernible images.
About Gamma Correction
When you select "Gamma Correction", and then press 8,you can
change the setting with
CI>
<::::0
8
8·
In
the example of the graph below, the horizontal
axis
shows
the
brightness level of the pictured recorded on the disc.
The
vertical axis
shows the brightness of the picture
output
by the
DVD-A
1
UDCI
o Resuming Initial Values after Gamma Correction
Press (
CUAR
1while a graph
is
displayed.
o
o
o
o
o
o
o
o
o
o
Default
7.5 IRE
GO
= 24 / G1 =32
G2 = 48 / G3 = 64
G4 =80 / G5 =96
G6 =
128/
G7 = 160
G8
= 192 / G9 = 224
0-+12
0-+3
0-+11
GO
- 9
-6
- +6
-6
- +6
-5
- +5
OIRE
7.5 IRE
-5
- +5
-6
- +6
-6
- +6
-6
- +6
Setting
contents
White Level
Adjust the white level.
Gamma Correction
Adjust video brightness in
detail.
Hue (color tone)
Adjust the green and red
color balance.
Contrast
Adjust picture contrast.
Sharpness (high range)
Adjust picture sharpness
for
the higher frequency range.
Setting items
Enhancer
Strengthens the contours
of
the picture.
DNR
Reduce noise in the entire
picture.
Sharpness (medium range)
*1
Adjust picture sharpness
for the medium frequency
range.
Brightness
Adjust picture brightness.
Setup Level *2
Adjust the black areas
of
the
image.
Chroma Level
Adjust the color density.
Black Level
Adjust the black level.
r+Ol(
:>.<
Refer
to
the table on the right regarding contents
of
items which
can be set.
1
Press~.
The currently set status
is
displayed.
3
Select the item you want
to
change
with
CI>
<::::0.
2
Select the memory number you want ("Memory
I"
-
"Memory
5")
with
CI>
<::::0,
and then press
8.
4 Change the setting with 8
8·
You
can
adjust the picture quality to your liking.
You
can
store up
to
a maximum of 5 values
in
memory.
The
picture adjustment set values are retained in memory even after
the power is turned off.
o When Finishing Picture Adjustment
Press
~
during picture adjustment.
o When Outputting Standard Picture Quality
without
Using Picture Adjustment
nAA
Q
Press 0 and
CI>
<::::0
to
select "Standard" and then press
v'
I
H.Position
Adjust the left/right position.
-7
- +7
o
V.Position
Adjust the
top/bottom
position.
-7
-
+7
o
*1 : This is not available for HDMI output.
*2 : Effective only for the 480i video signal from the video output terminal, S
video output terminal, and
component
video output terminal.
35
To Next Page
Loading...
