ENGLISH
The
Super Audio
CO
audio siqnal
is
a
44.1
kHz/16-bit Linear
PCM
output.
,
~.
I
16'9
Squeeze
Auto:
Output to a wide screen
TV
For
4:3 video, display
in
the center of the screen without changing the aspect ratio.
WIDE (16:9) : Output to a wide screen
TV
4:3
PS
: Output to a 4:3
TV
For
wide video, trim the left and right side
of
the image
and
display
in
4:3 aspect ratio. *1
4:3
LB
: Output to a 4:3
TV
Display
all
of the wide video. *2
480/576i. 480/576P, 720P, 1080i,
Source
Direct:
Output video using its source resolution. Convert the
1080p video source to 1080i.
Setting contents
Aut2 : Detect the type of video material
and
automatically switch the
mode. Normally, this setting
is
used.
Video1 : Suitable for playing video material discs.
Video2: Suitable for playing video material discs or 3D-frame film material
discs.
EuIJ
: Set when a home-use monitor
is
connected.
Normal:
This setting
is
used when video synchronization
is
disturbed
on
a professional-use monitor.
, This
is
not available for HDMI output.
Video Setup DefaJ.l1UeningsJuunderlined.
TV
Aspect (Aspect ratio)
Set the screen type
and
display mode of the
TV
Setting items
Component Resolution
Set the component output
resolution.
Progressive Mode
Set
an
appropriate
progressive conversion
mode for the source video
material.
TV
Active Area
Sets the horizontal display
range when the analog
video output resolution
is
480i/576i
*1 : Depending
on
the video content, even though you set the 4:3
PS
(pan
Scan),
the content may be
output
in
4:3
LB
(Letter
Box).
*2 :Only valid for content recorded
in
480i/576i.
HDMI Setup
Setting contents
~:
Super Audio
CO
audio
is
output.
Off : Super Audio
CD
audio
is
not output.
[Control]
• Off : Disable the HOMI control function.
• HDMI1
On
: Link with the device connected to HOMl1
• HDMI2
On
: Link with the device connected to HOMI2.
[Power Off Control]
•
On
:
Turns
the
OVD-A
1UOCl's power to standby through linkage to the
TV
•
Off:
Ooes
not turn the
OVO-A
1UDCI's power to standby through linkage
to the
TV
,
•
For
the HOMI control function to operate, it
is
necessary for the
OVO-
A1
UDCI
or
HOM
I-compatible
TV
connected to the
OVD-A
1
UOCI
to have
an
HOMI connection
• Refer to "HDMI Control Function" (l2if'page
49)
for more information
about the HOMI control function.
•
The
HOMI control function from the connected device becomes valid
when,
on
the
GUI
menu, "DENON
LINK
Setup" - "DENON
LINK
Mode"
is
set to "4th" (l2if'page
30).
• After the "HOMI Control" setting has been changed, always turn off the
power to the connected equipment
and
then turn it back
on.
Setting items
SA-CD Audio Out
Set to output stereo/multi
area
audio of Super Audio ,
CO
to the HOMI terminal.
HDMI Control
Can
operate the unit
in
conjunction with
an
HOMI
control support device.
'N'U-
If
you
set "DENON
LINK
Setup" - "OENON
LINK
Mode"
on
the
GUI
menu to "4th",
you
will
no
longer
be
able to change the "HDMI Control" - "Control" setting.
To
change the setting, switch "DENON
LINK
Mode" to a setting other than "4th" first
and
then change the setting.
Remote control operation
buttons
SETUP
o
.Displaying the menu
'Cancel the menu
.Moves the cursor
'(Up/Down/Left/Right)
:Decision the setting
RETURN
o
:Return to previous menu
26
To Next Page
Loading...
