26
Before use Connections
Basic
operations
Installing and setting up
supplied software
USB settings
Troubleshooting Index
Specifications
Signal system chart
Part names and
functions
Top panel
Q7 VINYL switching button (VINYL MODE)
ON:SwitchestoVINYLmode.
•The touch sensor is enabled when in VINYL
mode.
OFF: Switches to BEND mode.
•The touch sensor is disabled when in BEND
mode.
•Hold down u SHIFT and press this button to
disable the jog wheel operation (jog wheel lock
function).
Q8 Channel fader knob
Adjusts the mixing level for each deck.
Q9 Crossfader knob
Adjusts the output balance of the channel level.
W0 Channel input level adjustment knob
(LEVEL)
W1 Mixer control channel selection button
(DECK A/C , DECK B/D)
Sets the mixer control channel to A (C) or B (D).
•When o DECK CHG. is pressed, the control
channelswitchesinsynchronization.This
button can also be used to select individual
control channels.
W2 FX ON/OFF switching button (FX ON 1/2)
FX1:SwitchestheFlangerfunctionON/OFF.
•Hold down u SHIFT and press this button to
switchtheBrakefunctionON/OFF.
FX2:SwitchestheBeatGridfunctionON/OFF.
•Hold down u SHIFT and press this button to
switchtheBackspinfunctionON/OFF.
W3 Channel isolator EQ adjustment knob
(HI/MID/LOW)
Adjusts the input signal frequency response for
each channel.
•When aligned at the central position, the
frequency response is flat.
W4 Load button (LOAD A/C, LOAD B/D)
Functions differ depending on the window.
BROWSER: When DECK A (C) is selected using
o DECK CHG., the file selected using W5 SEL. is
loaded to DECK A (C).
When DECK B (D) is selected using o DECK
CHG.
, the file selected using W5 SEL. is loaded
to DECK B (D).
•Hold down u SHIFT and press the button to
load to either DECK C (A) or DECK D (B).
SAMPLER: Selects the SAMPLER DECK.
EFFECTS: Selects the EFFECT DECK.
RECORD: Not available.
Q3 Q6 Q9Q4 Q5 Q7
E5
E1
E4
E2
W9
E3
E0
Q8
W7
W5
W6
W4
W0
W1
W2
W3
W8
q
w
r
t
i
o
Q0
Q2
Q1
y
u
e