Denso HP3 - Removing the Feed Pump

11
(3) Remove the O-ring.
NOTE:
O-rings can not be reused.
3.4 Removing the Feed Pump
(1) Remove the three hexagonal bolts on the feed
pump cover.
• STT: Hexagonal Bit (95093-10030)
• STT: Driver Chuck (95992-10130)
(2) Remove the feed pump rotor set.
NOTE:
Please keep the rotor set in the same condition
(as a set).
NOTE:
Have the stamped side facing outward.
QD0871
QD0872
QD0873
QD0874