Denso HP3 - Installing the Fuel Temperature Sensor; Assembling the Feed Pump

34
(2) Using the hexagonal bit and the torque wrench
(STT), install the filter plug.
• Tool: Hexagonal Bit (8mm)
• STT: Torque Wrench (95096-10020)
• Tightening Torque: 14.8 to 22.8 N·m
(1.5 to 2.3 kgf·m)
4.7 Installing the Fuel Temperature Sensor
(1) Install the fuel temperature sensor.
NOTE:
Always use a new O-ring.
(2) Using the torque wrench (STT) and nozzle
holder, and the retaining nut wrench (STT),
fasten the fuel temperature sensor.
• STT: Torque Wrench (95813-10020)
• STT: Nozzle Holder, Retaining Nut Wrench
(95092-10500)
• Tightening Torque: 17.6 to 26.5 N·m (1.8 to 2.7 kgf·m)
4.8 Assembling the Feed Pump
(1) Install an O-ring.
NOTE:
Always use a new O-ring.
QD0071
QD1860E
O-Ring
QD0936
QD0937