Denso HP3 - Removing the Regulating Valve; Removing the Filter Sub-Assembly

13
3.6 Removing the Regulating Valve
(1) Using the regulating valve socket wrench
(STT), remove the regulating valve.
• STT: Regulating Valve Socket Wrench (95096-10181)
NOTE:
The regulating valve should only be removed
when there is some sort of abnormality with the
valve.
If there is no abnormality, do not remove the
valve.
Replace the regulating valve with a new valve
if, during the supply performance test it is
determined that the regulating valve is
malfunctioning. (Added Sept. 2005)
3.7 Removing the Filter Sub-Assembly
(1) Using a hexagonal wrench, remove the filter
plugs securing the filter sub-assembly.
• Tool: Hexagonal Bit (8mm)
QD0878
QD0879
QD0072