DENT Instruments powerscout 3037 - Field Installation; Mounting a Powerscout 3037

37
FIELD INSTALLATION
Once your PowerScout meter is set up for the desired communication method and protocol, it’s ready to
install out in the field.
Mounting a PowerScout 3037
PowerScout meters must be installed in an approved electrical panel or enclosure using proper
installation practices according to the local electrical codes.
 To mount the PowerScout 3037, use the two tabs provided at both ends of the case. Securely
mount the PowerScout near a dedicated circuit disconnect breaker.
W
ARNING! Remove the meter from all sources of voltage before mounting.
Mounting tabs,
located on each end
of meter case
PowerScout 3037 mounted
within electrical panel
Handle with care
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com