FEEDING TECHNOLOGY
12
4.8.2 New cycle delay
The new cycle delay is the length of time between the moment the screwdriver switches off and the
beginning of the separation and feeding process of the next feed part.
Minimum time: 0 sec.
Maximum time: 2,0 sec.
Steps: 0,1 sec.
4.8.3 Sep. forward
The separator forward time is the length of time the separator stays in inlet position.
Minimum time: 0,1 sec.
Maximum time: 10,0 sec.
Steps: 0,1 sec.
4.8.4 Air-push delay
The air-push delay is the length of time from the activation of the valve moving the separator
backwards to basic position until the activation of the valve for the air push.
Minimum time: 0 sec.
Maximum time: 5,0 sec.
Steps: 0,1 sec.
4.8.5 Part air-push
The part air-push is the length of time the valve is open for the air push. The part air push allows
adjustment of the reload procedure to correspond with the length of the feed hose. The part air-
push must be increased when using long feed hoses or when the air-push is on a low setting.
When using a shorter hose or strong air push then the part air-push time can be decreased.
Minimum time : 0,1 sec.
Maximum time: 5,0 sec.
Steps: 0,1 sec.
4.8.6 Time for SEGMENT DOWN
This is the duration of the activation of the valve for the segment-DOWN to activation of the valve
for segment-UP.
Minimum time : 0,1 sec.
Maximum time: 5,0 sec.
Steps: 0,1 sec.
4.8.7 Time for SEGMENT UP
This is the duration of the activation of the valve for the segment-UP to activation of the valve for
segment-DOWN.
Minimum time: 0,1 sec.
Maximum time: 5,0 sec.
Steps: 0,1 sec.
To Next Page
Loading...
Need help?
General
