FEEDING TECHNOLOGY
4
1 Introduction
The electronic sequence controller carries out all necessary controller tasks for the operation of the
feeder series 8. It is designed for optimal setting of the program sequence via the simple integrated
menu for any application.
To optimise the feed part cycle essentially the following points are decisive:
• Part time relative to part
• Length of the feed part
• Length of the feed hose
• Work tempo of the user
Different time settings can be fixed for up to 10 users. Switch between operators via the menu or
using RFID.
The controller has wide voltage input of 100-260V / 50/60Hz. Manual conversion between 230V
and 115V is not necessary.
The power pack is sustained short circuit proof.
The controller is switched on or off via the flip switch on the front of the machine. An LED displays
the power status.
Image 1: Sword feeder series 8 – example of use
The controller for the feeder series 6 is available for the following versions:
• 1811: Hand feeder
• 0811-EP: Stationary machine
• 0811-2-EP: Stationary machine with double/triple/quadruple distributor
To Next Page
Loading...
Need help?
General
