Deprag AST6 - User Manual

Questions and Answers

L
lauramyersAug 18, 2025
What to do if the Deprag AST6 shows temperature too high?
- J
  James JohnstonAug 18, 2025
  If the Deprag Controller indicates that the temperature is too high, first examine the screw process and make adjustments as necessary. If the problem persists, it is recommended to consult with the DEPRAG Service Department.
D
daviddillonAug 20, 2025
What to do if Deprag AST6 says 'Fieldbus not available'?
- B
  Beth HughesAug 21, 2025
  If the Deprag Controller displays 'Fieldbus not available!', verify that the fieldbus module is correctly installed and tightly mounted. If you no longer need to use the fieldbus module, you can deactivate it in the settings.
S
Stephanie WatsonAug 23, 2025
What to do if Deprag AST6 Controller shows power unit not found?
- T
  Travis GarciaAug 23, 2025
  If the Deprag Controller displays 'Power unit not found', switch off the AST6 and then switch it on again. If the fault persists, it is recommended to contact the DEPRAG Service Department.
R
Robert SmithAug 26, 2025
What to do if Deprag Controller shows no connection?
- K
  Kathy WilliamsAug 26, 2025
  If the Deprag Controller displays 'No connection', switch off the AST6 and then switch it on again. If the fault remains, please contact the DEPRAG Service Department.
J
Jerry HarrisonAug 28, 2025
What to do if Deprag AST6 shows no connection to fieldbus?
- H
  Hannah ThompsonAug 28, 2025
  If the Deprag Controller displays 'No connection to fieldbus!', switch off the AST6 and then switch it on again. If the fault remains, it is recommended to contact the DEPRAG Service Department.
M
Mr. Eric ThomasAug 30, 2025
What to do if Deprag Controller says screwdriver and controller are not compatible?
- S
  Steve EvansAug 30, 2025
  If the Deprag Controller indicates that the screwdriver and controller are not compatible, ensure that you have fitted an installation screwdriver to the AST6.
C
Carrie PhillipsSep 2, 2025
What to do if Deprag AST6 says SSC driver could not be loaded?
- C
  Craig ValenciaSep 2, 2025
  If the Deprag Controller displays 'SSC driver could not be loaded!', switch off the AST6 and then switch it on again.
K
Karen JonesSep 4, 2025
What to do if Deprag AST6 Controller says lost settings, default values will be loaded?
- L
  Lawrence ValenzuelaSep 4, 2025
  If the Deprag Controller displays 'Lost settings, default values will be loaded', check the settings and adjust them if necessary.
N
nelsonericSep 7, 2025
What to do if Deprag Controller displays position indicator index signal not found?
- J
  jillian72Sep 7, 2025
  If the Deprag Controller displays 'Position indicator index signal not found', ensure that the drive of the EC screwdriver can be turned freely. Then, restart the AST6.
S
sandovalalexSep 9, 2025
What to do if Deprag Controller shows "SYS_IO" output overloaded?
- Z
  Zachary OrtegaSep 9, 2025
  If the Deprag Controller displays '"SYS_IO" output overloaded', check the connections at the I/O interface.