H
higginsgregorySep 12, 2025
What to do if Deprag AST6 says screwdriver not found?
- EEric OneillSep 12, 2025
If the Deprag Controller indicates that the screwdriver is not found, insert a screw before you switch the AST6 on.
To Next PageTo Next PageWhat to do if Deprag AST6 says screwdriver not found?
If the Deprag Controller indicates that the screwdriver is not found, insert a screw before you switch the AST6 on.
What to do if Deprag Controller says I²C bus not opened?
If the Deprag Controller displays 'I²C bus not opened', check that the I/O interface is installed and mounted tightly. If necessary, please contact the DEPRAG Service Department.
General| Brand | Deprag |
|---|---|
| Model | AST6 |
| Category | Controller |
| Language | English |
Details the various connectors and their functions on the AST6 for communication and power.
Step-by-step guide for installing the AST6 sequence controller.
Details how to connect the AST6 to external control systems via I/O or fieldbus.
Explains usage of the touch display, including controls, menus, and input methods.
Guide to operating the AST6 using a web browser, including setup and navigation.
Instructions for updating the AST6 software.
General overview of system errors and troubleshooting steps.
Details specific errors that can occur during a screwing sequence.
