Deprag AST6 User Manual

83
20 Glossary
Term Description
Sequence controller see sequence controller
Sequence controller Controller to use with the EC or EC servo screwdriver
Switching off criteria Criteria to which the screwing application should e done (e.g.
torque, angle etc.).
Impact start The screwdriver starts as soon as the blade is pressed and
makes contact.
Command General program step to create the screwing sequence (e.g.
setting the output).
EC screwdriver The screwdriver has a brushless electronic drive (EC motor,
English abbreviation for electronic commutate).
EC servo screwdriver The screwdriver has a brushless electronic drive (EC motor,
English abbreviation for electronic commutate) and has an
integrated, sensor controlled torque and angle of rotation
measurement.
Encoder visual sensor to detect the current position of a motor shaft or
an drive unit
End value dataset The dataset in which all result data for the screwing
application is stored.
Ethernet Data network technology for local data networks to exchange
data between all devices connected in a network (computer,
printer, etc.).
EtherNet/IP Ethernet-based fieldbus for the control and data exchange
with sequence control resp. the base station, developed by
the company Allen-Bradley
EtherCAT Ethernet-based fieldbus for the control and data exchange
with sequence control resp. the base station, initiated by the
company Beckhoff
Handheld screwdriver Screwdriver to use at hand-work places
Main controller Component for processing the screwing programs
High Signal level +24V
Power element Component for the motor control of the screwdriver
Low Signal level 0V
Process ability index (C
p
) C
p
= total specific torque tolerance of the
Connection: 6 Sigma (s).
This index just provides information about the spread angle of
the torque values.
s
eUntergrenzObergrenze
C
p



6

Deprag AST6 Specifications

General

Brand	Deprag
Model	AST6
Category	Controller
Language	English