31
It is possible for you to create a standard program, if there is no program available.
For this, tap the "standard program" button.
Select the desired screwing program and confirm your selection by tabbing the "Accept"
button.
The desired program is created by the sequence controller AST6.
If you did not enter a password then only the set values are displayed.
Changes and the writing of standard programs are not possible.
8.2.3.4 Test Menu
Figure 17: Test Menu
The test menu offer different tests for the sequence controller AST6 as well as for the EC
screwdriver (also refer to Diagnosis).
The system test shows the current status of the sequence controller AST6.
Different tests for the EC screwdriver an be performed in the tool test menu. These are
torque, angle and rotation test. For a detailed description, refer to Screwdriver Test
.
The sequence test provides the possibility to process the individual screwing programs
step-by-step. For example, to limit problems during parametrization. For a detailed
description, refer to Sequence Test
.
8.2.3.4.1 Interface Menu
Der Schnittstellentest bietet die Möglichkeit, die Schnittstellen der Ablaufsteuerung AST6
zu testen. For a detailed description, refer to Interface.
To Next Page
Loading...
Need help?
General
