Deprag AST6 User Manual

52
9.2 Default Values
The default values can be adjusted as follows:
• at the control in the system menu  tab the setting on the general page to "set
default values"
• click the "reset" button in the web interface in the setting menu  default settings
9.2.1 General Parameters
Parameter Value
Language english
Unit for torque N•cm
Main direction of rotation right
Password 0000
Baud rate auto
Rotation speed decrease active
Signal sound never
Offset gear Gear transmission ratio 1
Efficiency 100%
Direction change no
Fieldbus Available no
Control via I/O interface inactive
Statistic: Limits for CP/CPK value +/- 15%
Table 12: Default Values
9.2.2 Special parameters for fieldbus systems (optional)
9.2.2.1 Profibus
Parameter Value
Profibus address 64
Table 13: Default values for Profibus
9.2.2.2 Profinet
Parameter Value
IP address 10.10.24.10
Net mask 255.255.00
Gateway 10.10.20.9
Station name nic 50 repns
Table 14: Default values for Profinet
9.2.2.3 Ethernet IP
Parameter Value
IP address 10.10.24.11
Net mask 255.255.0.0
Gateway 10.10.20.9
DHCP inactive
BOOTP inactive
Table 15: Default values for Ethernet IP
9.2.2.4 Ethercat
No settings are necessary.

Deprag AST6 Specifications

General

Brand	Deprag
Model	AST6
Category	Controller
Language	English