Deprag SZG Controller 6 - Page 3

FEEDING TECHNOLOGY
3
4.11.2 COUNTER................................................................................................................................... 15
4.11.3 PART ASSEMBLY TIME.............................................................................................................. 15
4.11.4 COMBINED ................................................................................................................................. 16
5 OPTIONAL ACCESSORIES......................................................................................................... 17
5.1 INLET CONTROL / HOSE SCREW SENSOR (HOSE)................................................................. 17
5.2 FILL LEVEL SENSOR (BIN)......................................................................................................... 17
5.3 RFID............................................................................................................................................18
5.4 PC-SOFTWARE........................................................................................................................... 19
6 CABLE LAYOUT.......................................................................................................................... 20
6.1 PROVIDING OF EXTERNAL PING FOR TYPE X811 WITH CONTROLLER................................ 20
6.2 PROVIDING OF EXTERNAL PING FOR TYPE 0811-2-EP/1,5.................................................... 20
6.3 SIGNAL DURATION FOR START 1 – 2 (ONLY TYPE EP).......................................................... 21
6.4 INPUTS ....................................................................................................................................... 21
6.5 PLUG CONFIGURATION............................................................................................................. 22
6.6 OUTPUTS.................................................................................................................................... 22
7 ERROR MESSAGES / OPERATIONAL STATUS......................................................................... 23
8 SERVICE STATIONS AND AUTHORIZED PARTNERS............................................................... 24
NOTE:
The controller 362625 B is based on the feeder controller SZG CONTROLLER 6 and
is only to be used in connection with a sword feeder from DEPRAG SCHULZ GMBH u
CO. Please pay attention to the further instructions for use in the technical
documentation of the associated feeder.