SGX VIBRATOR MOTOR
15 Jun 12 7-7
HyperPoolShaker
Mounting Hardware Installation
Note! Due To High Torque Applied During Installation, Re
-Use of Motor
Is Not Recommended. All Hardware Components Should
Be Replaced Whenever A Motor Is Removed.
The motor is secured to the screen frame with 3/4” bolts. When installing the bolts, note that the
3/4” motor bolts are installed from the underside of the screen frame (Figure 7-1). Hardened
washers are required under the bolt heads as well as under the Flex-Loc nuts.
G0001973 3/4” x 4” Lg 1-1/8” Hex Hd 1-1/8” / Deep Socket
Figure 7-1. Motor Bolt Installation
To Next Page
Loading...