SGX VIBRATOR MOTOR
7-22 15 Jun 12
HyperPoolShaker
Bearing Installation (Cont’d)
3 - After heating inner bearing race, slide
bearing race onto motor shaft until
shoulder of race contacts bearing seat in
rear of cavity. Fully coat surface of inner
race with grease (supplied with bearing
replacement kit).
4 - Orient longer, reduced diameter of
bearing mount toward motor body. Align
clearance holes in bearing mount with
threaded holes in bearing housing, and
press bearing mount fully into bearing
housing cavity.
5 - Locate the two clearance holes in
bearing mount 180degrees apart. Insert
two M8-1.25x70 jack bolts supplied with
bearing replacement kit through the
clearance holes, and thread screws into
holes in bearing housing. Alternately
advance both jack bolts a few turns at a
time until bearing mount is drawn well into
bearing housing.
6 - After bearing mount has been
sufficiently drawn into bearing housing,
remove the two jack bolts and install
original socket head cap screws (M8-
1.25x60) into the six clearance holes.
Hand tighten screws.
To Next Page
Loading...