DERRICK HYPERPOOL SHAKER User Manual

SGX VIBRATOR MOTOR
15 Jun 12 7-21
HyperPoolShaker
13 - Using a soft absorbent cloth, remove
excess lubricant from interior of bearing
housing and inner bearing race. Do not
use compressed air for cleaning as this
may drive contaminants into motor.
14 - Using a torch with a diffused flame,
gently heat inner bearing race for no more
than 10 seconds to approximately 200°-
230°F (93°-110°C) to facilitate removal.
15 - Carefully remove and discard heated
inner bearing race from motor shaft. Using
a soft absorbent cloth, remove excess
lubricant from interior of bearing housing.
Do not use compressed air for cleaning as
this may drive contaminants into motor.
Bearing Installation
1 - Remove inner bearing race from
assembled bearing and bearing mount
supplied with bearing replacement kit. Be
careful to avoid contaminating these
components.
2 - Wipe excess lubricant from inner
bearing race, and position on motor shaft
with collar toward motor body. Using a
bearing heater or a torch with a diffused
flame, heat inner bearing race to
approximately 200°-230° F (93°-110° C).

DERRICK HYPERPOOL SHAKER Specifications

General

Brand	DERRICK
Model	HYPERPOOL SHAKER
Category	Engine
Language	English