Designability WizzyBug - Fig. 30 Move the Seat to the Top Holes; Fig. 31 Making the Seat Depth Longer

32
Adjusting the seat depth when it is fitted in the Wizzybug
To make the seat depth longer (for example if your child has
grown):
1. Unclip the carer control from the back of the headrest and
raise both armrests (see page 24).
2. Turn the white dial fully anti-clockwise to unlock the seat.
3. Make sure that the seat pins are in the
highest position in the metal grid. If they
are not, use your thumb to squeeze the
black seat release knob and lift the seat
so that the seat pins line up with the top
holes. Release your thumb so that the
pins fit into the top holes.
(If the pins do not fully fit into the holes,
check that the front corners of the seat
are sitting in the two metal slots above
the front of the battery compartment,
and check that the white dial is fully
unlocked.)
4. Reach under the back of the seat base and pull up the back of
the seat base as far as you can, and tilt the backrest all the
way forward until it clicks. The seat depth is now one size
longer and has a new colour setting.
Fig. 31 Making the
Seat Depth Longer
Fig. 30 Move the Seat to the Top Holes