Model FP-700
FP-700 Instruction Manual Rev. 5.1 Page 43 of 46
9.2 Spare Parts, Sensor Accessories, Calibration Equipment
Part Number Spare Parts
FP-700 Intelligent Transmitter Module (ITM)
FP-700 ITM with Cell, Lower Housing, and Splashguard Adapter
Model 700 Housing Bottom Assembly (includes Flame Arrestor)
Replacement Plug-in Sensor
Sensor Accessories
NEMA 7 Aluminum Enclosure less cover – 3 port
NEMA 7 Aluminum Enclosure Cover (Blank)
NEMA 7 316SS Enclosure less cover – 3 port
NEMA 7 316SS Enclosure Cover (Blank)
Sensor Splashguard with integral Cal Port
(Included for use in Performance Certificate)
Harsh Environment Sensor guard
(Not Included for use in Performance Certificate – Will reduce the
response time of the unit particularly on Heavy Hydrocarbon gases)
Condensation prevention packet (for J-Box replace annually)
Calibration Accessories
Threaded Calibration Adapter
Span Gas Kit: Includes calibration adapter, span gas humidifier,
200cc/min fixed flow regulator, and carrying case. (Not including
Span Gas cylinder: 50% LEL Methane balance air
Contains 104 liters of gas and is good for 175 calibrations
Span Gas cylinder: 25% LEL Methane balance air
Contains 104 liters of gas and is good for 175 calibrations
200cc/min Fixed Flow Regulator for span gas bottle
Recommend Spare Parts for 2 Years
FP-700 Intelligent Transmitter Module (ITM)
Housing Bottom Assembly (includes Flame Arrestor)
Replacement Plug-in Sensor
Condensation prevention packet (for J-Box replace annually)
1
Contact Detcon Customer Service for a complete part number