KEYPAD FUNCTIONS
DO NOT operate the keypad with pointed objects (pencils, pens, etc).
Damage to keypad resulting from this practice is NOT covered under warranty.
This is the ON/OFF key. With the indicator off, pressing this key will apply
power to the indicator and turn on the display. If the indicator is already on,
pressing the key again will turn the indicator off.
Basic Functions
This is the ZERO key. It is used to reset the display to zero up to the selected
limit of either 4% or 100% of the scale capacity. The zero limit is set during
setup and calibration of the indicator.
This is the UNITS key. It is used to change the weighing units to the alternate
units of measurement. For example, with pounds displayed, pressing this key
will change the weighting units to kilograms. NOTE! This feature must be
enabled during setup and calibration for this key to be operational.
8555-M483-O1 Rev A x 750 Owner’s
8
To Next Page
Loading...
Need help?
General
