Detecto 750 User Manual

SETUP AND CALIBRATION, CONT.
BAUD=
(SERIAL OUTPUT BAUD RATE)
Press the BMI/ENTER key to view the current setting. If value displayed is acceptable, press
the BMI/ENTER key again. Otherwise, press the a or b keys to scroll through and select a
new value and then press the BMI/ENTER key to save it and proceed to the next prompt.
Allowable values are: 1, 2, 3 or 4.
1 = 4800 Baud 2 = 9600 Baud 3 = 19.2k Baud 4 = 38.4k Baud
niCAd
(Battery Type Selection)
This setting determines whether Alkaline, NiCad or NiMH batteries are used for battery
operation.
Press the BMI/ENTER key to view the current setting. If the value displayed is acceptable,
press the BMI/ENTER key again. Otherwise, press the a or b keys to scroll through and
select a new value and then press the BMI/ENTER key to save it and proceed to the next
prompt. Allowable values are: 0, 1, or 2.
0 = Alkaline batteries - battery charging is DISABLED
1 = NiCad or NiMH batteries - battery charging is ENABLED
2 = Battery charging is ENABLED and FORCED ON. This selection forces
battery charging for NiCad or NiMH batteries that are discharged.
CAUTION! Selecting 1 or 2, enables battery charging. DO NOT select 1 or 2,
when using Alkaline batteries.
SLeeP=
(Sleep Mode)
The Sleep Mode feature also conserves battery power when the indicator remains unused for
a period of approximately 1 to 9 minutes. When enabled, the load cell excitation will be
reduced and the display will show
SLEEP
. The Sleep feature requires the indicator to remain
at the center of zero to activate, unlike Automatic Shutoff feature which only requires no
motion. Weight placed on scale will activate indicator and return it to weight mode.
Press the BMI/ENTER key to view the current setting. If the value displayed is acceptable,
press the BMI/ENTER key again. Otherwise, press the a or b keys to scroll through and
select a new value and then press the BMI/ENTER key to save it and proceed to the next
prompt. Allowable values are 0 through 9 with 0 disabling Sleep Mode
ASH=
(Automatic Shutoff)
The Automatic Shutoff feature will turn the indicator off after a period of approximately 1 to 9
minutes of inactivity to prolong battery life. You must press the ON/OFF key to turn indicator
back on.
Press the BMI/ENTER key to view the current setting. If the value displayed is acceptable,
press the BMI/ENTER key again. Otherwise, press the a or b keys to scroll through and
select a new value and then press the BMI/ENTER key to save it and proceed to the next
prompt. Allowable values are 0 through 9 with 0 disabling Automatic Shutoff.
Setup and Calibration Is Completed
The setup and calibration process has been completed. The indicator will reset and then
display weight. Remove power from the indicator and re-assemble for use. The indicator is
now ready for normal operation.
8555-M483-O1 Rev A x 750 Owner’s
18

Detecto 750 Specifications

General

Readability	0.2 lbs
Display	LCD
Power	AC adapter or battery
Connectivity	RS232
Functions	BMI