24
3
26 432 0
OIL
Engine Operation
3.1 Commissioning
3.1.1 Adding Engine Oil
As a rule, engines are delivered empty of oil.
Pour lube oil into the oil filler neck (arrow).
For oil grade and viscosity, see 4.1.
3.1.1.1 Initial Engine Oil Fill-Up
for B/FM1011F Series
● Fill oil into the oil sump up to the “max.” mark on
the engine dip stick (for oil top-up quantity see
9.1).
● Start the engine and allow to run at a low idling
speed for approx. 2 mins.
● Switch off the engine.
● Check the oil level, if necessary, top up oil to the
„max.“ mark.
If the person operating the engine does not run up
the engine until the thermostat opens, the oil level
may lie above the „max“. mark on the engine dip
stick when delivered. The level can then only be
assessed after the engine has been run up.
3.1.1.2 Initial Engine Oil Fill-up
for B/FM 1011F Series
● Fill oil into the oil sump up to the “min.” mark on
the engine dip stick.
● In addition, top up the oil quantity of the supply
hoses and of the external oil cooler (according to
manufacturer’s details).
● Allow the engine to run warm until the thermostat
opens (at approx. 95
o
C).
● Allow the engine to run for approx. 2 mins.
● Switch off the engine.
● Check the oil level, and if necessary, top up oil to
the „max.“ mark.
To Next Page
Loading...
