EasyManua.ls Logo

Deutz BL 1011F - Three-Phase Alternator; Lifting Tackle

Deutz BL 1011F
82 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
64
Service and Maintenance
6
26 434 0 26 435 0
1
2
!
6.7 Accessories
6.7.2 Three-Phase Alternator
Notes on the three-phase system:
Never disconnect the cables between battery,
alternator and regulator while the engine is run-
ning.
If, however, it is necessary to start and operate
the engine without the battery, disconnect the
regulator from the alternator before starting.
Be sure not to confuse the battery terminals.
Replace defective bulb of the charge pilot lamp
immediately.
When washing the engine, cover up the alterna-
tor and regulator.
The habit of touching a lead against the frame to
check whether it is live must under no circum-
stances be used with three-phase electrical sys-
tems.
In case of electric welding, connect the ground
terminal on the welder directly to the piece being
welded.
6.7.3 Lifting Tackle
Always use proper lifting tackle 1 when trans-
porting the engine.
After transportation and before commissioning
of the engine:
Remove attachment eyes 2.
Use only the correct lifting tackle.

Related product manuals