Devolo Magic 2 WiFi 2-1 - 2.3 Pairing - Establishing a PLC connection

15 Introduction
devolo Magic 2 WiFi
2-1
2.3 Pairing – Establishing a PLC
connection
devolo Magic adapters that are in the factory de-
fault condition, i.e. have been recently purchased
or successfully reset (see Chapter 3.5 Removing
the devolo Magic adapter from a PLC network),
automatically start to attempt to pair (establish a
PLC connection) with anotherdevolo Magic adap-
ter when reconnected to the mains supply.
Starting up a new devolo Magic PLC network
After plugging the devolo Magic adapters into
available power sockets, a new devolo Magic net-
work is established automatically within 3 minutes.
Fig. 2: devolo Magic 2 WiFi
2-1
with country-specific
connector and power socket
Fig. 3 Network connectors