25 Initial use
devolo Magic 2 WiFi
2-1
Please note that your computer or other de-
vice must have a network card or network
adapter with a network interface.
To set up a devolo network, you need at
least two devolo adapters.
3.3 Connecting the
devolo Magic 2 WiFi
2-1
CAUTION! Damage to the device caused
by ambient conditions
Only use device indoors in dry conditions
In the following sections we describe how to
connect the devolo Magic 2 WiFi
2-1
and integrate
it into a network. We clarify the exact procedures
based on potential network scenarios.
For the permitted voltage range for opera-
ting the device and the power consumpti-
on, refer to the type plate on the rear of the
device. For additional technical information
on our products, refer to the product area at
www.devolo.global.
3.3.1Starter Kit – Automatic set-up for a
new devolo Magic PLC network
1 Connect one devolo Magic 2 LAN
1-1
to your
Internet access device's network connection
(e.g. your Internet router).
CAUTION! Tripping hazard
Lay the network cable in a barrier-free
manner and ensure that the electrical
socket and the connected network de-
vices are easily accessible
2 Plug both devolo Magic adapters into available
power sockets within 3 minutes. As soon as the
LEDs on both adapters flash white at regular
intervals of 0.5 sec., they are ready to operate
and automatically start the process of establis-
hing an encrypted connection to each other
(see Chapter 2.3.1 Reading the PLC indicator
light).
If the LEDs on both devolo Magic adapters
light up in white, then your devolo Magic
network has been set up according to your
individual specifications and is protected
from unauthorised access.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
