DeWalt DW168F - Recoil Starter

28


XX. Recoil cover
YY.8mmscrews(5)
ZZ. Recoil starter spring
A1. Starter reel
B1.Studs(4)
C1. Friction spring
D1. Reel cover
E1. Ratchet
F1. Reel cover screw
G1. Starter rope
H1. Recoil Base
I1. On/Off Switch
(compressorandpressurewasher)
J1.Nuts(4)
K1.Supportbracket
L1. Weather stripping
M1. Snap ring
Before reassembling recoil cover
(XX)removeanydirtordebris.
WARNING: Risk of unsafe operation. Always wear
gloves and c
ertified safety equipment: ANSI Z87.1 eye
protection (CAN/CSA Z94.3) with side shields when assembling
and disassembling.
XX
YY
G1
Before reassembling
starter rope check
for fraying and wear,
replace if needed.
A1
ZZ
D1
E1
C1
C1
Before reassembling check ratchets
(E1)forwear,ifneededreplace.
H1
NOTE: UnhooktheOn/Offswitch(I1)
beforeremovingtherecoilbase(H1).
I1
Before reassembling lubricate moving parts
(C1,E1,F1)withbearinggrease.
CAUTION: Risk of unsafe
operation.
Carefully remove
starter reel (A1) from recoil
cover (XX). Spring will unwind
very quickly.
F1
J1
K1
L1
B1
M1