1312
NOMAD
• Exposed to heat or fire
• Housing opened
The NOMAD Pro 2 Handset is considered a consumable with a 1-2 year service life
depending on usage patterns. The handset should be replaced when it no longer powers
the device for 3 days of typical use without re-charging.
Do not operate the NOMAD Pro 2, the handset, charging cradle, or AC power
supply if equipment was subjected to moisture (wetting, immersing, or soaking).
Return to DEXIS or authorised service centre for service.
• Do not open the housings. Doing so will void the warranty. There are no user
serviceable parts inside the NOMAD Pro 2, handset, charging cradle, or AC power
supply.
• The NOMAD Pro 2 should not be used in environments where flammable cleaning
agents are present.
• Locate the charging cradle away from the normal patient environment.
• Connect only items that are specified as part of the system or that are specified as
being compatible with the system.
2.4 Cleaning
Use a non-acetone based disinfectant wipe or a cloth to wipe the exterior surfaces
of the NOMAD Pro 2 and charger. Do not use cleaners intended for hard surfaces, since
certain chemical combinations may deteriorate the NOMAD Pro 2 plastic prematurely.
Leave the handset connected to the NOMAD Pro 2 and wipe down all surfaces of the
device.
Unplug the charging cradle before cleaning.
NOTE: The NOMAD Pro 2, the handsets, the charging cradle, and the AC power supply
are not designed to be subjected to any kind of sterilisation procedure.
Alignment Bars
It is recommended to follow facility established cleaning and disinfection procedures. If the
infection control guidelines in your country permit, the alignment bars can be disinfected
using appropriate cleaning agents. Refer to cleaning agent manufacturer instructions.
Do not spray disinfectant or cleaners directly on the NOMAD Pro 2, handsets, charging
cradle, or AC power supply. The connecting areas are open to ingress and damage to
your device may result.
To Next Page
Loading...
