DEXIS NOMAD Pro 2 - Charging the Handsets

76
• AC/DC Power Supply
• Universal Alignment Bar
• Short Endodonic Alignment Bar
• Short Bitewing Alignment Bar
• NEMA 1-15p USA pin Cord
• Certificate of Conformance, Getting Started Guide, Product Registration Card, and
NOMAD Pro 2 Operator Training CD
 Preliminary Checks:
Item Check
Device Labels Verify that the serialised device label is in place (located on lower side of
unit).
Other Labels Verify that the serial number on the warranty/registration card matches
the device serial number on the device and the device serial number on
the carrying case. Verify that the handsets’ label (located on the top of
each handset) and the charging cradle label (located on the bottom of the
charging cradle) are all in place.
Collimator Cone and
Backscatter Shield
These two items provide operator protection and should be inspected for
shipping damage.
Trigger Switch Should freely move in and out when depressed and released.
Device Housing Should be free of cracks or fractures.
 Complete the product registration card and mail it with proper postage to Dental
Imaging Technologies Corporation today, or go on-line at dexisimaging.com/en-us/product-
warranty-registration. Registering your device will activate your DEXIS Complete (the first
year is free). For terms and conditions of NOMAD Pro 2, please visit www.dexis.com.
 Clean the NOMAD Pro 2. Use a non-acetone based disinfectant wipe or a cloth to
wipe the exterior surfaces of the NOMAD Pro 2 and charger. Do not use cleaners intended
for hard surfaces, since certain chemical combinations may deteriorate the NOMAD Pro 2
plastic prematurely.
1.4 Charging the Handsets
NOMAD Pro 2 charging system includes rechargeable handsets, a Charging Cradle and
an AC/DC Power Supply. The AC/DC Power Supply has a removable power cord which
plugs into an AC electrical outlet (universal voltage accommodated).
DEXIS NOMAD handsets and DEXIS NOMAD charging cradles are compatible with both
DEXIS and KaVo branded Charging Cradles, Handsets and AC/DC Adapters.
• Handsets must be charged before initial use. Alternate handsets each week to
maximise service life.
• Do not spray disinfectant or cleansers directly on to the handsets.
• Do not attempt to charge below 10
o
C or above 40
o
C.
• Charge the Handsets before use and after any extended period of inactivity.