Dexter Laundry T650 - C-Series Accessories

C-Series Accessories
Key Description T650 T750 T950 T1450 QTY
* Hose, Water Supply 3/8” I.D. x 48” 9990-027-011 2
* Hose, Water Supply 5/8” I.D. x 48” 9990-027-013 9990-027-013 2
Hose, Water Supply 5/8” I.D. x 48” 9990-027-013 4
* Washer, Inlet Hose (furnished) 8641-242-000 8641-242-000 8641-242-000 8641-242-000 2
* Strainer, Inlet Hose (furnished) 9565-003-001 9565-003-001 9565-003-001 9565-003-001 2
* Bevel Washer for 5/8” bolt used in installa-
tions using angle iron bases
* Bevel Washer for 3/4” bolt used in installa-
tions using angle iron bases
8641-586-003 8641-586-003 8641-586-003 8641-586-003 4
* Sealing compound 8538-151-001 8538-151- 001 8538-151-001 8538-151- 0 01 1
* TORX#20 8545-051-002 8545-051-002 8545-051-002 8545-051-003 1
* Special Tool For Removing Coin Acceptor
Mounting Screws. (T-10 Torx)
8545-051-003 8545-051-003 8545-051-003 8545-051-003 1
* Flow Restrictors (in dispenser ) 9475-002-002 9475-002-002 9475-002-002 9475-002-002 2
* Battery (used on Control PCB) 8612-001-001 8612-001-001 8612-001-001 8612-001-001 1
* Special Tool for adjusting spacing between
outer tub front and cylinder front
8545-056-001 8545-056-001 8545-056-001 8545-056-001 1
* Clamps to hold tub front to outer tub when
installing tub front
Vise Grip #11R Vise Grip #11R Vise Grip #11R Vise Grip
#11R
1
* Coin Bearing & Seal Kit 9732-219-006 9732-219-006 9732-219-006 1
* Key Service Lock (6324) 6292-006-007 6292-006-007 6292-006-007 6292-006-007 1
* USB, Thumb Drive (Blank) 9150-045-001 9150-045-001 9150-045-001 9150-045-001 1
* USB, Thumb Drive, W/File 9150-045-002 9150-045-002 9150-045-002 9150-045-002 1
WC0650-XA12ECX 208-240 volts 60hz Single Phase or Three Phase
WC0750-XA12ECX 208-240 volts 60hz Single Phase or Three Phase
WC0950-XA12ECX 208-240 volts 60hz. Single Phase or Three Phase
WC01450-XA12ECX 208-240 volts 60hz Single Phase or Three Phase
102
Part # 8533-093-001 1/18
102