DFI HU101 - Page 42

42
Chapter 3 BIOS Setup
Chapter 3
WatchDog Configuration
This section sets the system watchdog parameters.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
WatchDog Parameters
WatchDog Count Mode
WatchDog TimeOut Value
Advanced
[Second]
0
 Select Screen
 Select Item
Enter: Select
+/
-:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
WatchDog Count Mode
Selection
WatchDog Count Mode
Selects the watchdog count mode.
WatchDog TimeOut Value
Enters the watchdog timeout value. 0 means disabled.
Network Stack
This section is used to enable or disable UEFI network stack.
Enable/Disable UEFI
network stack.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Network Stack
Advanced
[Disabled]
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Network Stack
Ipv4 PXE Support
Ipv6 PXE Support
Advanced
[Enabled]
[Enabled]
[Enabled]
Enable/Disable UEFI
network stack.


Enter:
+/
-:
F1:
F2:
F3:
F4:
ESC:
Select Screen
Select Item
Select
Change Opt.
General Help
Previous Values
Optimized Defaults
Save & Exit
Exit


Enter:
+/
-:
F1:
F2:
F3:
F4:
ESC:
Select Screen
Select Item
Select
Change Opt.
General Help
Previous Values
Optimized Defaults
Save & Exit
Exit
When Network Stack is enabled, it will display the following information: