35
2
Hardware Installation
If you are using a USB 2.0 device, install the “Intel USB 2.0 Drivers”
that is in the provided CD. Refer to chapter 4 for more information.
Wake-On-USB Keyboard
The Wake-On-USB Keyboard function allows you to use a USB
keyboard to wake up a system from the S3 (STR - Suspend To
RAM) state. To use this function:
• BIOS Setting:
“USB KB Wake-Up From S3” (“PM Wake Up Events” field) in
the Power Management Setup submenu of the BIOS must be
set to Enabled. Refer to chapter 3 for more information.
Important:
• If you are using the Wake-On-USB Keyboard function for 2
USB ports, the 5VSB power source of your power supply
must support
≥
1.5A.
• If you are using the Wake-On-USB Keyboard function for 3
or more USB ports, the 5VSB power source of your power
supply must support
≥
2A.
To Next Page
Loading...
