72
3
Award BIOS Setup Utility
IDE Primary Master/Slave UDMA and IDE Secondary Master/
Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is
selected, the BIOS will select the best available option after checking
your hard drive or CD-ROM.
Auto The BIOS will automatically detect the settings for
you.
Disabled The BIOS will not detect these categories.
On-Chip Serial ATA Setting
On-Chip Serial ATA
Disabled Disables the onboard serial ATA.
Auto The system will automatically detect the serial ATA
drives and set them to the available master/slave
mode.
Manual Select this option to manually configure the serial
ATA drives in the “Serial ATA Port1 Mode” and
“Serial ATA Port2 Mode” fields.
Serial ATA Port1 Mode and Serial ATA Port2 Mode
These fields are used to select the master/slave mode of the
serial ATA drives. When you select Primary Master, Primary Slave,
Secondary Master or Secondary Slave, make sure they do not
conflict with the settings of the IDE hard drives.
When Logical Primary is selected, the other port will
automatically be set to Logical Secondary and vice versa. Logical
Primary or Logical Secondary sets the drives to master mode.
Since both drives are in master mode, the system will not be
able to detect the IDE drives.
To Next Page
Loading...
