Diamond DA 42 - Page 167

DA 42 AFM
Normal Operating
Procedures
Doc. No. 7.01.05-E Rev. 8 15-Dec-2017 Page 4A - 15
3. Left Wing:
a) Entire wing surface .................... visual inspection
b) Tank air outlet on lower surface .......... visual inspection
c) Tank drain/tank air inlet ................ drain off to check for water and
sediment (drain until no water
comes out) / visual inspection
d) Openings on lower surface .............. check for foreign objects and for
traces of fuel (if tank is full, fuel
may spill over through the tank
vent)
e) Stall warn device...................... visual inspection
f) Tank filler ........................... visual inspection, check closed
g) Pitot probe .......................... clean, orifices clear, cover
removed, no deformation
h) Wing tip............................. visual inspection
i) Static dischargers ..................... visual inspection
j) Position light, strobe light (ACL) .......... visual inspection
k) Tie-down............................ check, clear
l) Aileron and linkage .................... visual inspection
m) Aileron hinges and safety pin ............ visual inspection
n) Foreign objects in aileron paddle ......... visual inspection
o) Flap and linkage ...................... visual inspection
p) Flap hinges and safety pin .............. visual inspection
q) Nacelle underside fuel cooler air in- & outlet check, clear
r) Step ............................... visual inspection
CONTINUED