DA 42 AFM
Handling, Care,
Maintenance
Doc. No. 7.01.05-E Rev. 8 15-Dec-2017 Page 8 - 13
8.5.3 MOORING
Near the lower end of the tail fin of the airplane there is a hole which can be used to tie
down the airplane to the ground. Also on each wing near the wing tip, an eyelet with a
metric M8 thread can be installed and used as tie-down points.
8.5.4 JACKING
The airplane can be jacked at the two jackpoints located on the lower side of the center
wing's LH and RH root ribs as well as at the tail fin.
To Next Page
Loading...
