Diamond DA 42 - Gearbox Oil Level Check; Tire Inflation Pressure Check

Handling, Care,
Maintenance
DA 42 AFM
Page 8 - 6 Rev. 8 15-Dec-2017 Doc. No. 7.01.05-E
8.4.3 GEARBOX OIL LEVEL CHECK
1. Open the inspection door on the forward left side of the lower cowling.
2. Check gearbox oil level in inspection window.
3. Close the inspection door.
4. Repeat steps 1 to 3 for the other engine.
8.4.4 TIRE INFLATION PRESSURE CHECK
1. Remove dust cap from valve stem by turning counterclockwise.
2. Connect tire gauge to valve stem, read pressure.
3. Correct pressure if necessary
(nose tire: 6.0 bar / 87 PSI,
main tires: 4.7 bar / 68 PSI if OÄM 42-195 is installed,
4.5 bar / 65 PSI if OÄM 42-195 is not installed)
4. Install dust cap on valve stem by turning clockwise.