Diamond DA 42 - 4.12 Check Gear (if Installed); 4.13 Raim Unavail

Abnormal Operating
Procedures
DA 42 AFM
Page 4B - 22 Rev. 8 15-Dec-2017 Doc. No. 7.01.05-E
4B.4.12 CHECK GEAR (IF INSTALLED)
CHECK GEAR
Landing gear is not down and locked.
1. Landing gear ......................... down / as required
NOTE
If installed the CHECK GEAR caution message is displayed
when either the flaps are in LDG position or one POWER
lever is less than approx. 20 % and the landing gear is not
down and locked.
END OF CHECKLIST
4B.4.13 RAIM UNAVAIL
INTEG
RAIM not available
RAIM (Receiver Autonomous Integrity Monitor) is not
available.
(a) Enroute, Oceanic, Terminal, or Initial Approach Phase of Flight
If the RAIM UNAVAIL annunciation is displayed in the enroute, oceanic, terminal, or initial
approach phase of flight, continue to navigate using the GPS equipment or revert to an
alternate means of navigation other than the G1000 GPS receiver appropriate to the route
and phase of flight. When continuing to use GPS navigation, position must be verified
every 15 minutes using the G1000 VOR / ILS receiver or another IFR-approved navigation
system.
END OF CHECKLIST