5. proGrammInG
In order to program the LEIT-1
™
, you must first let the unit sit out in the light to
charge. In bright light conditions (full sun) this will take under 30 minutes.
In shaded conditions this could take up to 2 hours.
This section explains the programming features, and the steps necessary to assign
irrigation schedules. To program the controller use the
to select the desired
programming mode, the
to make the entry flash and the buttons to
change the value.
NOTE: Only a flashing value can be changed.
NOTE: If the last data entered stops flashing, press again to resume
programming and repeat the steps.
6. seTTInG TIme anD DaTe
The controller can display the time in either a 12 or 24 hour format.
To change the time format, from the home screen:
1. Press and hold the
button for three seconds until the display switches
format (AM/PM disappears).
SETTING THE CURRENT TIME AND DATE
To enable the controller to operate properly, the current time and date must
be set.
1. Press the
button, until the icon appears along with the time and the day
of the week.
8
To Next Page
Loading...
Need help?
General
