DIG LEIT-1 User Manual

9. seTTInG WaTerInG run TImes
Note: If you have already set a SimpleSmart
™
ET preset (example: SP02) and then
change the run time, your SimpleSmart
™
program will be turned OFF. You must
reactivate the SimpleSmart
™
programming each time you adjust your run time
(see section 10).
This setting determines the length of time the LEIT-1
™
smart controller will allow
the valve to remain open (duration is from 1 minute up to 6 hours). For example,
setting watering run time to 10 minutes on certain days of the week will program
the controller to turn the water on for 10 minutes on each of the days chosen and
at every start time selected.
To set the watering run time
:
1. Press the button until the icon appears and OFF or the last run time
setting appears.
2. Press the
button, and OFF (or the last run time programmed) appears with
hours flashing.
3. To set a desired watering run time in hours, press
or and select the
number of hours.
4. If only watering duration in minutes is required, press to skip the hour digit,
and the minutes will start flashing.
14

DIG LEIT-1 Specifications

General

Brand	DIG
Model	LEIT-1
Category	Controller
Language	English