About the development board Port descriptions
Digi Connect ME, Wi-ME, ME 9210, Wi-ME 9210 Hardware Reference Manual
22
Placement of module
CAUTION! When handling the development, wear a grounding wrist strap to avoid ESD
damage to the board.
Port descriptions
The development board provides the following ports:
n Primary serial port, P1
n Secondary serial port, P2
n GPIO port, P7
See the figure titled Board layout and connector locations for the location of the ports. The following
sections describe the ports.
Primary serial port, P1
The primary serial port is a DB-9 male connector that is labeled as P1 on the development board. See
the following figure for pin orientation; see the following table for pin assignments.
To Next Page
Loading...
