Digi Connect ME - Page 69

Regulatory information Europe
Digi Connect ME, Wi-ME, ME 9210, Wi-ME 9210 Hardware Reference Manual
69
Standards Digi Connect ME
Emissions AS/NZS 3548
AS/NZS 3548 CISPR 22
Japan IOH
003NY04115 0000
003GZ04064 0000
FCC Part 15 Subpart C
(FCC ID: MCQ-50M880)
IC RSS 210 (IC:1846A-50M880)
FCC Part 15 Subpart B
ICES-003
EN 55022
EN 61000-4-2
EN 61000-4-3
EN 61000-4-6
EN 301 489-3
EN 300 328
VCCI
FCC Part 15 Subpart B
ICES-003
EN 55022
EN 61000-4-2
EN 61000-4-3
EN 61000-4-6
EN 301 489-3
EN 300 328
VCCI
Immunity EN 55024 EN 55024
Safety UL 60950-1
CSA 22.2 No. 60950--1
EN 60950
UL 60950-1
CSA 22.2 No. 60950--1
EN 60950
Antenna configurations
This device has been designed to operate with the antennas listed below, and having a maximum gain
of [10] dBi. Antennas not included in this list or having a gain greater than [10] dBi are strictly
prohibited for use with this device. The required antenna impedance is [50] ohms
The following antenna configurations that were tested with the Connect Wi-ME 802.11 b module.
Digi 29000095, Bobbintron SA-006-1, +2 dBi dipole antenna (NP-SMA)
PCTEL, MLPV2400NGP, 2.4 GHz, 3dBi gain, no ground place, low profile antenna