ConnectCore for i.MX51
©2011DigiInternational,Inc. 18
90 RGB IOG_BACK i.MX51: IOG_BACK Not used
91 GPIO18 JTAG_TCK i.MX51: JTAG_TCK JTAG Connector
92 GPIO18 JTAG_TRST# i.MX51: JTAG_TRST# JTAG Connector
93 GPIO18 JTAG_TMS i.MX51: JTAG_TMS JTAG Connector
94 GPIO18 JTAG_MOD# i.MX51: JTAG_MOD# JTAG Mod Selection
95 GPIO18 JTAG_TDI i.MX51: JTAG_TDI JTAG Connector
96 GPIO18 JTAG_DE# i.MX51: JTAG_DE_B JTAG Connector
97 GPIO18 JTAG_TDO i.MX51: JTAG_TDO JTAG Connector
98 LVIO RESET_IN# i.MX51: RESET_IN_B
MC13892: RESETB
Not used Warm reset input to i.MX51.
99 LVIO POR# i.MX51: POR_B
MC13892: RESETBMCU
LCD 1 & 2 Reset, JTAG
Connector and Reset Button (S4)
Cold reset input to i.MX51.
Used to reset the module and
peripherals on the Dev. Kit.
100 - +1.8V -
101 - GND -
102 - GND -
103 ETH ETH2_TX+/ETH2_DA+ ETH_CTRL: TPO+ Ethernet 1 Tx+
104 ETH ETH2_RX+/ETH2_DB+ ETH_CTRL: TPI+ Ethernet 1 Rx+
105 ETH ETH2_TX+/ETH2_DA- ETH_CTRL: TPO- Ethernet 1 Tx-
106 ETH ETH2_RX+/ETH2_DB- ETH_CTRL: TPI- Ethernet 1 Rx-
107 - - - - -
108 - - - - -
109 - - - - -
110 - - - - -
111 GPIO33 ETH2_ACTIVITY# ETH_CTRL: GPIO1/LED2# Ethernet 2 Activity LED
112 GPIO33 ETH2_LINK# ETH_CTRL: GPIO0/LED1# Ethernet 2 Link LED
113 GPOIO18 EIM_CS0/GPIO2_25 i.MX51: EIM_CS0 Peripheral Application Chip Select
114 GPOIO18 EIM_CS1/GPIO2_26 i.MX51: EIM_CS1 Not used
115 GPOIO18 EIM_CS2/GPIO2_27/
FEC_RDATA2/SISG5/
CSI1_D4/AUD5_TXD
i.MX51: EIM_CS2 Not used
116 GPOIO18 EIM_CS3/GPIO2_28/
FEC_RDATA3/
SSI_EXT2_CLK/
CSI1_D5/AUD5_RXD
i.MX51: EIM_CS3 Not used
Pin I/O Type Signal name Use on module Use on development board Comments
Downloaded from Elcodis.com electronic components distributor
To Next Page
Loading...
Need help?
General
