003 & 003 Rack Getting Started Guide86
To toggle a send between pre- and post-fader
operation:
1 Press the Send switch to put 003 in Send View.
2 Press the Channel Select switch under a send
name to toggle its pre- and post-fader setting.
Insert View Workflows
When the Insert switch is enabled (lit), 003 is in
Insert View. In this view, the LCD shows the
names of currently-assigned inserts (hardware
inserts or plug-ins) across all channel strips for a
given insert position (Inserts A–E in Pro Tools).
If a hardware insert or plug-in is selected in
Pro Tools, its name flashes in the LCD.
In this view, you can display inserts, plug-in
controls, bypass plug-ins, and assign inserts in
Assign mode.
Working with Inserts
To display the inserts on an Insert position (A– E):
1 Press the Insert switch (Console View section)
to put 003 in Insert View.
2 Press the corresponding Insert/Send Position
switch A–E.
The names of all inserts on that track are dis-
played in the LCD. (While the names of hard-
ware I/O inserts are displayed, they have no ed-
itable parameters, so the Channel Select
switches and the rotary encoders have no effect
on them.)
To display the controls for a plug-in:
1 Press the Insert switch (Console View section)
to put 003 in Insert View.
2 Press the corresponding Insert/Send Position
switch A–E.
3 Press the Channel Select switch under a
plug-in name.
003 goes into Channel View and displays the
plug-in’s controls across all channel strips. Con-
trols are assigned to the rotary encoders.
Switched controls (such as Master Bypass or
Phase Invert) are controlled by Channel Select
switches.
4 To display additional pages of plug-in controls
(if any), press the Left and Right Page switches.
To bypass a plug-in:
1 Press the Insert switch (Console View section)
to put 003 in Insert View.
2 Hold Command/Ctrl and press the Channel
Select switch under the plug-in name.
The LCD screen displays the name of bypassed
plug-ins in all capital letters.
For information on assigning inserts in As-
sign mode, see “Assigning Pro Tools Paths
(Input, Output, Sends, Inserts)” on page 92.
The Left or Right Page switch flashes when
an additional page is available.
To Next Page
Loading...
Need help?
General
