C|24 Guide96
Scrubbing while Trimming a Region or
Selection
(Pro Tools HD Only)
To use Trim/Scrub mode:
1 Navigate to a region or selection you want to
trim.
2 Press the Trim switch.
3 Press the Scrub switch.
4 Rotate the Scrub/Shuttle wheel to move the
cursor to the trim location.
5 To trim to the cursor location or to the begin-
ning of the selection, press the Trim switch
again.
Shuttling Audio in the Edit Window
(Pro Tools HD Only)
To use Shuttle mode:
1 While Pro Tools is stopped, press the Shuttle
switch.
2 Rotate the Scrub/Shuttle wheel clockwise to
shuttle forward, or counter-clockwise to shuttle
backward.
3 To exit, press the Shuttle switch again.
Auditioning Start and End Points
of Selections
In Audition mode, you can listen to either the
start or end of a selection, with or without pre-
roll or post-roll.
To play audio starting at the pre-roll point up to the
start of a selection:
1 Press the Audition switch so that it is lit.
2 Press the Pre-Roll switch.
To play audio starting at the selection start
through the length of the post-roll amount:
1 Press the Audition switch so that it is lit.
2 Press the Mark In switch.
To play audio back-timed from the selection end by
the pre-roll amount:
1 Press the Audition switch so that it is lit.
2 Press the Mark Out switch.
To play audio starting at the end of a selection
through the post-roll amount:
1 Press the Audition switch so that it is lit.
2 Press the Post-Roll switch.
To trim to the end of a selection, hold
the Opt/Alt (all) Modifier switch while
pressing the Trim switch.
To Next Page
Loading...
