The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential. Any disclosure, copying, distribution to third
party
is strictly prohibited.
12
Mechanical Movement Sensor
How to assemble the sensor box
SENSOR
Screws B Screws B
Screws A
Clamps
Clamps
Screws (A)
Sha
36 m/m
Sheathing
Speedometer
Cable
Sensor Prove
1. Take out the internal wire from the
sheathing.
2. Shorten the shea ng 36 m/m
3. Insert both ends of the sheathing in the
clamps and ght the 4 screws B
4. Loosen the 4 screws (A) and insert
the internal wire. Do not ght the 4
screws A*.
* A en on: when you insert the internal
wire, the dummy sha must come out
and be dispose
A) Re-assemble the trasmission cable in the car, connec ng it to
both the gear box and the odometer.
B) Drive about 100 mts to allow the internal wire to fi nd its origi-
nal posi on.
C) Tight the 4 screws A.
D) Insert the sensor’s prove.
E) Fix the sensor’s cap to end the sensor’s assembling opera on
and to have the sensor fully opera ve
Electrical Connec ons
Red cable = Power Supply (5 Vcc to 24)
White cable = Output Signal (open collector)
Shield = Ground
To Next Page
Loading...
