The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential. Any disclosure, copying, distribution to third
party
is strictly prohibited.
24
Sta s cal Memory
How to Erase the Loca ons Memory Content
The taximeter records and keeps data in 2 Memory Blocks, each one divided in 45 loca ons.
The content of both Block1 and Block2 can be erased (if allowed by the setup).
STATIS
5.00 1 28
FOR HIRE
FOR HIRE
Memory Data
Memory Block
Memory Loca on
Number
Erasing Procedure
How to erase Block2 (if allowed by set up)
Select For Hire posi on.
Press K1 and K2 at the same me.
The big display will show “Sta s” for a few seconds.
Reach loca on n. 28 by pressing K2 bu on.
Reach loca on n.28, insert the Service Programming Key 1 and
press K4 bu on to erase all informa on contained in Block 2.
If you want to erase and print, select posi on 18 instead of 28
(block 1 and block 2 informa on will be printed)
Reach the memory loca on n. 29 by pressing K2 bu on.
Reach loca on n. 29, press K4 bu on to erase all informa on con-
tained in Block 1.
If you want to erase and print, select posi on 19 instead of 29
(block 1 and block 2 informa on will be printed)
Reach the memory loca on n. 30 by pressing K2 bu on.
Insert the service programming key 1, reach loca on n. 30 and
press K4 bu on to erase all informa on contained in both Blocks
1 and 2.
If you want to erase and print, select posi on 20 instead of 30
(block 1 and block 2 informa on will be printed)
Press OP bu on to end the erasing procedure and go back to
For Hire posi on.
0.00 1 28
Memory Data
Memory Block
Memory Loca on
Number
0.00 1 29
Memory Loca on
Number
5.00 1 29
5.00 1 30
Memory Loca on
Number
0.00 1 30
How to erase the Block 1 (if allowed by setup)
How to erase both Block 1 and Block 2 (if allowed by setup)
Advanced Func ons enabled by pressing K4 with the Service Programming Key 1
Loc. Block Memory Content
4 1 Erase all the “Trip by Trip” Memories (wait a few seconds to complete)
5 1 Reset “driver by driver” buff er
6 1 Reset the Ticket Number
7 1 Reset and Load the Factory Ticket Header
8 1 Reset and Load the Factory Prog. Date
9 1 Reset the monthly buff er
10 1 Reset and Load the Factory Tariff
17 2 Total Reset and Load all the Factory Parameters
18 1 Erase Memory Block 2 (even if not allowed by setup) and prints blocks 1 & 2 (if printer is connected and ON)
19 1 Erase Memory Block 1 (even if not allowed by setup) and prints blocks 1 & 2 (if printer is connected and ON)
20 1 Erase Memory Blocks 1-2 (even if not allowed by setup) and prints blocks 1 & 2 (if printer is connected and ON)
28 1 Erase Memory Block 2 (even if not allowed by setup)
29 1 Erase Memory Block 1 (even if not allowed by setup)
30 1 Erase Memory Blocks 1-2 (even if not allowed by setup)
1
2
3
To Next Page
Loading...
Need help?
General
