The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential.
Any disclosure, copying, distribution to third
party is strictly prohibited.
23
Sta s cal Memory
How to Print Loca ons Memory Content
The taximeter records and keeps data in 2 Memory Blocks, each one divided in 45 loca ons.
The content of both Block1 and Block2 can be printed out.
How to print the memory blocks informa on
Example: How to print out the Over Speed Report
Print Out Reports by pressing K4
STATIS
3 1 5
0 1 5
FOR HIRE
FOR HIRE
Memory Data
Memory Block
Memory Loca on
Number
Select For Hire posi on.
Press K1 and K2 at the same me to enter in the “Sta s cal
Reading “ mode.
The main display (3)will show “Sta s” for a few seconds.
Reach the memory loca on n. 8 by pressing K2 bu on.
Reaching loca on n. 8, press K4 bu on to print out the
contents of both Block 1 and Block 2.
The printer will start prin ng
Press OP bu on to end the prin ng procedure and go back to For
Hire posi on.
Select For Hire posi on.
Press K1 and K2 at the same me to enter in the “Sta s cal
Reading “ mode.
The main display (3) will show “Sta s” for a few seconds.
The secondary display (5) shows in the right digits the loca on n. 1
(rela ve to the Over Speed memory loca on) and in its le digits
the Block number.
Press K4 bu on to print out the Over Speed events.
Press OP bu on to end the prin ng procedure and go back to For
Hire posi on.
Memory Data
Memory Block
Memory Loca on
Number
Loc. Block Memory Content
1 1 Overspeed report
2 1 “Trip by Trip” report of all stored events
3 1 “Trip by Trip” report star ng from the last printed events
4 1 “Trip by Trip” report of last 50 events
5 1 ----------
6 1 ----------
8 1 Sta s cal Memories - Blocks 1-2
9 1 Monthly report (by pressing K4 it goes to a submenu to select the month desired and print it by pressing again K4)
16 1 “Driver by Driver” report (by pressing K4 it goes to a submenu to select the driver number desired or all drivers and print
the report of the driver selected by pressing again K4)
18 1 Print Blocks 1&2 and reset Block 2 (The reset of Block 2 will be done only with the service programming key 1 inserted)
19 1 Print Blocks 1&2 and reset Block 1 (The reset will be done if allowed by tariff setup)
20 1 Print Blocks 1&2 and reset Block 1&2 (The reset of Block 1 will be done if allowed by tariff setup and the reset of Block 2
will be done only with the Service Programming Key 1 inserted)
28 1 Reset Block 2 (Only with the Service Programming Key 1 inserted)
29 1 Reset Block 1 (If allowed by tariff setup)
30 1 Reset Blocks 1&2 (The reset of Block 1 will be done if allowed by tariff setup and the reset of Block 2 will be done only
with the Service Programming Key 1 inserted)
STATIS
3 1 1
1 1 1
FOR HIRE
FOR HIRE
Memory Block
One Spread Loca on
Number
To Next Page
Loading...
Need help?
General
