Digitax M1 mdt - E-Seal- Electronic Sealing; 2 Nd Section

The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential.
Any disclosure, copying, distribution to third
party is strictly prohibited.
15
“E-Seal”- Electronic Sealing:
2nd Sec on
By pressing K2 key in the E-Seal Mode is possible to read the second sec on. Press K4 to go to the next event, press
K3 to go to the previous event. Press OP to exit. It can be displayed in the following format:
Exit to the main menù
K-CONS 0
A.DEFL 0
TARIFF 0
SYN.CL 0
TICKET 0
M.E.S. 0
CL.MEM 0
DEFAUL 0
LB.RES 0
AVAIL 0
LIGHTS 0
PAIRIN 0
CLOCK 0
AVAIL 0
BIOS 0
Note:
At any event posi
on by pressing K1 the E-Seal counters report will be printed
Press K2 at any me to come back to the E-Seal fi rst sec on
* Pairing event is shown but is never generated
*