The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential.
Any disclosure, copying, distribution to third
party is strictly prohibited.
17
Pre-Selec on of the Tariff
In order to avoid possible fraudulent use of the taximeter, it is possible to ac vate an alterna ve way of star ng a
trip, that allows to select the desired tariff when the taximeter is s ll in For Hire posi on, and so to start the trip
directly with the pre-selected tariff .
Tariff pre-selec on is ac vated by changing the following setup ques ons:
Q32=yes
Q2=0
Q3=number of tariff s
When Pre-Selec on is enabled:
pressing K1 key from “For Hire” posi on is shown the
Tariff Selec on menu, and the driver has to select the
tariff number.
To start with scrolling through the tariff s with K3 (up)
and K2 (down).
The selected tariff is confi rmed by pressing K1 key again,
and so the taximeter starts the trips directly with the
Pre-selected tariff .
If the tariff is not selected in 5 seconds, the taximeter
goes back to “For Hire” posi on
TARIFF 3
TARIFF 4
TARIFF 2
TARIFF 2
To Next Page
Loading...
